Flow Cavitative Erosion for Component Cleaning

  Cavitation Areas

In many casting processes, unwanted material deposits - so-called blinds - are created by mould cavities. Up to now, these have had to be removed manually in subsequent process steps and thus necessitate increased production effort of the cast components and thus higher costs. By means of flow-cavitative component cleaning, fully automatic deburring and cleaning is to be made possible, whereby the simulation of these effects and subsequent validation are the focus of this research project.

 
Benefit Procedure
Innovative cleaning concept Simulation of cavitation and deburring processes
Understanding the processes of cavitation Validation of the physical principles on a test bench
Evaluation of the cleaning efficiency through erosion processes Implementation and optimization in an industry-oriented demonstrator

Contact

Phone

work
+49 241 80 47726

Email

E-Mail
 

Challenge of Cleaning Simulations

Despite increasing computer capacities and speeds, cleaning and deburring simulations have hardly been realized so far. In particular, the interaction between fluid and solid, the so-called fluid-structure interaction, represents a great challenge in simulation technology. Within the context of this project, a further step is to be taken into the simulative description of a new type of cleaning process, in which the targeted generation of cavitation in the vicinity of undesired structures causes material removal and thus a locally limited cleaning effect. In practice, the successful simulation can be used, for example, to precisely define tolerances for the mould elements so that shearing of the unwanted material is just about possible.

 

Test Bench Development

Demonstrator Demonstrator

A test bench was developed at ifas to validate the simulation results. A test specimen is clamped between two matrices, which can be varied in shape and material composition. For the first tests, it is modelled from a thin aluminium foil and provided with a corresponding opening cross-section. During the test, water flows through this foil, whereby on the one hand a force is exerted on the foil by the fluid impulse, and on the other hand an acceleration of the fluid takes place due to the cross-sectional narrowing of the aperture-like sample geometry, so that the static pressure in this area decreases and leads to cavitation phenomena. During the execution of the test, a high-speed camera is used for visual documentation of the bubble formation, whereby its occurrence, size and implosion are evaluated in post-processing. The pressure before as well as after the blind can be adjusted, whereby the primary control variable is the amount of negative pressure after the demonstrator. The preload of the liquid reservoir at the input serves only to amplify the effects.

 
Test Bench Setup Test Bench Setup
 

Isolation of the Effects

A central result is on the one hand the assessment of the extent of the cleaning effect and on the other hand the determination of which physical phenomena are predominant for the cleaning process. Thus, the influence of the fluid impulse is to be isolated by setting the correct boundary conditions and thus conclusions can be drawn about the extent of cavitation erosion. Finally, the test rig serves to optimise the cleaning process under technical and economic aspects.

 
 

Acknowledgement

Logo of the Federal Ministry of Economics and Energy

This research project is supported by the Bundesministerium für Wirtschaft und Energie (BMWi) within the context of the Zentralen Innovationsprogramms Mittelstand (ZIM).

  Copyright: ZIM
 
 

Publications

-